Implementación de dos módulos técnicos para prácticas de domótica e inmótica mediante protocolos de comunicación X10 y HDL Buspro.

Abstract

This work had as objective the development of two practical modules of domotic and the elaboration of their respective manuals of practices where it explains in detail the operation and programming of the modules that use the protocols X10 like Buspro property of HDL. Its development was based on a three-stage process: physical design, electrical design and programming. The practical Domotic Modules were implemented in both technologies with the devices corresponding to a level 1 installation of domotization, according to the “Domotization Levels Table” of the Spanish Association of Domotic and Inmotic (CEDOM), in this way they were compared in a way Equitable. The results of the cost-benefit analysis were obtained through the use of the descriptive methodology where the price of both technologies was determined by the control outputs. The difference in prices is not marked and even based on the parameters with which the analysis was performed, in specific applications the price of equipment with technology Buspro have a lower cost than equipment using X10; but determining the total cost of the equipment within an X10 domotic network is the most economical option. Both technologies allow the development of domotic and inmotic applications, because of the maximum number of X10-enabled computers within a network, it is not feasible to implement it in large-scale applications. The use of the manuals during the operation of the module is recommended.