Procedimiento Específico para la Instalación de Medidores de Deformación Tipo Vw-Spotweld Strain Gauge Sobre Oleoductos.

Abstract

A SPECIFIC PROCEDURE FOR THEINSTALLATION OF TYPE VW- SPOTWELD DEFORMATION GAGES ON OIL PIPELINES has been established to provide a basic manual which will serve as a guide in the abovementioned process. During the procedure development all the necessary requirements were taken into accounts uccessfully and without any fault, the deformation gage installation stressing the human factor, his/her security and training; for this, a joint training plan was elaborated. The procedure obtained with the investigation work has clearly defined its. Objectives and reach, the required staff to successfully carry out the deformation gage installation, the security norms to be accomplished by both, the work sites and the staff involved, the materials, tools and necessary equipment for the work, the activities com prising the installation process, putindetail, stepbystep, withback-up photos, the care and considerations in connecting them to the control cabinet and the correct way to carry to carry out measurements. Moreover, the procedure is completely defined trough an organization organigram, the management levels and the responsibility of each one of them during the deformation gage installation process. The installation can be copied, modified and suited to the requirements presenting the installation sites or the sector where the deformation gages are to be placed.